cnc router x axis starting before y axis finished when pocketing ?

[Robin Oakapple]

I've attached the toolpath

The CNC router is made by Rob Whittaker, he advertises on eBay

https://www.ebay.co.uk/itm/CNC-Route...0AAOSwt6RdtyD5

I' very happy with the one he made me, and I will be part exchanging it for an 8 x 4 as soon as he's finished it. I don't have any connection with him apart from being a very happy customer.

I contacted him about the problem that is the subject of this thread, and he advised me to go to General Config in Mach3 and check the 'turn off cv in corners'. I've done that but haven't had a chance to try it out since.

Although I've been using the machine for a good few months I'd have to confess I have so far only learned enough to get it to do the work I need it to do (I make kitchens, it's very much a production machine). I should, and will, eventually, try to learn more.

Thanks for your help, it's much appreciated..