Quote Originally Posted by depronman View Post
I am using linuxcnc on an Orac lathe. Using two parallel ports one on motherboard and a pci card running an encoder limit switches and a number of control panel buttons. Cycle start stop pause etc. It’s been rock solid since I set it up after the conversion some 8 months ago
I’ve used mach3 but linuxcnc is just sooooo much better
Gmaccopy is a major improvement over axis as a screen interface. All I can say is it just works where as Mach3 would and still does on my other cnc lathe have its moments
I would go to linuxcnc on that one as well but I invested in a pokeys motion controller and don’t want to bin that so mach3 will love on for the time being

Paul


Sent from my iPhone using Tapatalk

Quick question
When i looked into linuxcnc, it said once installed do not update the linux distro.
Is that still the same today or have they found a way to allow update of the linux, was thinking about caelinux as its geared towards cad etc, can linux cnc be added to cae at all