Rotary axis, z lift before rotate query

[JAZZCNC]

Easy if you just want to change this code just swap the lines to this.

G00 Z143.4785
A-45. F10160.

But if you want this to happen all the time then you may need to alter the post-processor, there will be a section for initialization or pre-amble or setup whichever it calls it, at the moment these are the first 2 lines in your code with the codes G00 G49 G40.1 G17 G80 G50 G90 G21

I don't use Rhino Cam so can't say but there may well be a setting that lets you lif the Z-axis to a safe position first. Most Cam programs have this feature.