Xyz malfunction very slow movement

[T3pbd]

Hi Jazz,
I just type xy or z and then the value ie, y25 etc will check jog speed etc thanks for you ideas.regards Phil

[JAZZCNC]

Hi Jazz,
I just type xy or z and then the value ie, y25 etc will check jog speed etc thanks for you ideas.regards Phil

Ok well, then it depends on what Mode the Machine was last used in because some moves are what they call Modal and will stay in effect. So if your last command was a G1 move then it will travel at whatever feed rate was set last, In code, this would look something like G1 x25 Y25 F1000. The F-number being the feed rate you wanted to cut at.
The Set Feed rate will also show on the Mach screen in the Feedrate section.

Try typing G0 x25 y25 in MDI at it will move at rapid speed which is the Max velocity the machine is tuned to move at. If it's still slow then maybe you do have an issue or the Feed Override is set low, but you would see this on mach's screen with a flashing red light in the override LED.