Hardinge Lathe CNC Retrofit/Conversion

[Chaz]

Surely it's only the drive you require not the motor.? this wouldn't cost a fortune to replace. What is the model number of the drive, so I can check it against mine which does supposedly work with single-phase, though I haven't tried it, and will use 3 phase anyway?

Thanks.

I thought so too, so queried with them, reckon no go as the motor is wired for 380V. I did notice when I connected it they only expose 3 wires, so cant change from high to low voltage.

The drive is SZGH-S4T7P5, the motor is SZGH10-3-48-7.5/11-4-1500.



Thanks