Thread: Beavermill conversion to CNC
-
13-09-2010 #101
First we put the flange on the machine and made holes in it so we can use them later as a center for alignment for milling the arcs of the part.
And start with roughing .
-
13-09-2010 #102
After making sure the workpiece is in the center of the machine I started with
roughing the outer arc.
-
13-09-2010 #103
After that we are roughing the cylindrical section and then turn over the workpiece and cut away the biggest arc.
But first we made the small arc .
-
13-09-2010 #104
After finishing the outer arc the arc shaped slots ware made.
-
13-09-2010 #105
In a later stage the piece is taken in the chuck of my lathe.
The first operations are facing of and drilling .
-
13-09-2010 #106
With a other tool we made the chamber for the motor.
-
13-09-2010 #107
After turning over the workpiece the other side is machined .
-
13-09-2010 #108
Now the workpiece is going back to the milling machine and it is centered and holes ware made in to it so the motor can be attached .
-
13-09-2010 #109
In to the side of the flange a tapped hole is made to attach a handle for tightening the belt of the motor.
-
13-09-2010 #110
now the motor flange is ready for paint.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CONVERSION: Archdale Conversion
By meyerga00 in forum Conversion Build LogsReplies: 0Last Post: 17-06-2012, 09:24 AM -
Mill conversion to cnc
By wolsey in forum General DiscussionReplies: 1Last Post: 15-08-2011, 11:07 PM -
Bridgeport Conversion
By Tony Goodwin in forum Bridgeport Milling MachinesReplies: 0Last Post: 08-08-2011, 08:11 AM -
Sieg sx2 conversion kit
By Goldigger in forum Milling Machines, Builds & ConversionsReplies: 3Last Post: 24-04-2011, 07:42 PM -
A little conversion tool
By D-man in forum Computer SoftwareReplies: 1Last Post: 18-12-2010, 04:58 PM
Bookmarks