Anyone know why my machine is not cutting what I tell it to in CUT2D

[depronman]

Is the motor /step calibration correct

Ie if you tell it to move 200mm does it actually move a measured 200mm
The longer length you can check it over the more accurate
Other than that does it repeat when goi g to and from a set point. Ie is it loosing steps

Paul


Sent from my iPhone using Tapatalk

[JAZZCNC]

I'm going to assume you have the steps per setting because without this being correct your wasting your time doing anything else.

Which vectric software is it.? I've recently noticed some of their lower-end products have a limit on cut size. Could it be this.?

Does it repeatably cut the wrong size or is the size random.? if it's random then check your motor couplings etc haven't come lose and your getting slippage. You need to establish that it repeatably gets it wrong before changing settings as it could be mechanical.