CNC6040Z controller

[JAZZCNC]

There are quite a few Divas on here but I haven't seen any mystic Meg's yet and we can't afford crystal balls so your going to have to give us clue.!

Mach3 doesn't get any easier to use and to be honest just about every control software out there works the same regards cutting parts. ie: you load G-code, set Zero for each axis then push cycle start.!

Mach3 needs setting up with the correct pins and motor tuning setup before it will work correctly. But this is the same for every other control software and it's just part of setting up the machine and control software.
If you are struggling with Mach3 then you won't find it any easier using a different software and NONE of them will set your machine up automaticly, even if they say they do, because every machine is different and can be wired in many ways. with the Chinese machines, you have a box of chocolates in that you never know what you going to get, hence why it looks different to all the others.!

Help us help you by giving better info, if not then we can't help it's that simple.