Old software for Denford machines

[m_c]

There were a few variations in how machines were named, so I wouldn't worry about what the badge says.

IIRC a 93 machine will still be the old serial controller, unless it's been upgraded to the later USB controller.
If it still works, it'll work with Denford's VRMilling software, but performance will be limited over serial. If it has been upgraded to USB, I personally wouldn't be in any rush to upgrade anything, unless it's faulty.

VRMilling uses pretty generic FANUC g-code. There is a guide on the Denford forums to check setup, but I only ever used a Mach post-processor in whatever CAM I was using, and it seemed to work fine.