6040Z controller

[JAZZCNC]

I do need to hold my hands up here, Jazz - as Richard said - I did advise him to ask on the forum for specific help on Mach3 (in this case the configuration for shared limit/home switches - I think from reading the PDF that is all managed by Mach3 / Input configuration, but without a working installation to test that I'm flying blind).

Yeah, there's a lot of conversation behind the scene here which I did try to help catch up with the relevant bits on the forum with my post (and discard the obsolete/rabbit-hole info), simply, it's a lot of noise that would have run to many pages and with many threads.

Ye I get that Doody and I weren't having a pop at you, like me you give your time for free and out the kindness of your heart so I would never have a Pop at anyone for this but Richard came back asking for more help and gave virtually Zero Info knowing so much had happened behind the scenes, Saying he's new is NO excuse because he's the one who's done the pyshical modifications you told him to do.

You know me I don't pussy foot about with my words, I haven't got time to waste being all PC just so someone, who I'm trying to help for Free, doesn't gets offended.

That's fine with me Jazzcnc looking through the posts I did give the information as I saw it, then Doddy by kindly came in and supplied all the information in a polite way,before you replied with your abrupt reply,
I object to being called a "snowflake" which I am certainly not.and regardless of disagreements this forum is not a place to call each other names

Richard, I wasn't complaining about what you wrote I was making the point that by doing this ON and OFF the forum doesn't work and makes it difficult for Us not privy to what's happened so far to help. So my point was do one or the other not both because I haven't got time to go back thru dozens of posts trying to catch up on what's happened or read an update post that is 10,000 words long.

More than Twice now on two separate threads you have gone off the handle at reply's which were never said or meant to offend only help, but you read them differently and got offended. In my world, this makes you a snowflake.

Now here's the last piece of advice you'll get from me.!. . . If you are going to hang around Forums asking for help you are going to need to realise we are all different and text is easily misread and took the wrong way, getting upset at the words being said or asked is only going to isolate you from the people who have the knowledge and experience to help fix your issues.

Good luck.!