. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 01-11-2020 #6
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    I don't think you can control the spindle speed with this board as it doesn't have an analog output or speed controller built into it. The speed control it mentions in the manual I think is an analog Input where you connect a POT to control the Feed rate. The Relay is just used to Start/Stop the spindle.
    -use common sense, if you lack it, there is no software to help that.

    Email: [email protected]

    Web site: www.jazzcnc.co.uk
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to JAZZCNC For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. HY VFD and spindle at low speed
    By Neale in forum General Electronics
    Replies: 9
    Last Post: 26-09-2018, 08:47 AM
  2. Spindle Speed Control
    By Kev2960 in forum Chinese Machines
    Replies: 5
    Last Post: 17-02-2017, 07:08 AM
  3. Irregular Spindle Speed
    By HipoPapi in forum Spindles & Drive Motors
    Replies: 26
    Last Post: 07-07-2016, 06:07 PM
  4. So Nearly there - Mach3 and VFD Spindle Speed.
    By davegrennan in forum Artsoft Mach (3 & 4)
    Replies: 11
    Last Post: 11-04-2015, 12:30 AM
  5. High speed spindle
    By leadinglights in forum Tool & Tooling Technology
    Replies: 0
    Last Post: 27-04-2010, 09:23 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules