Thread: Heart shaped trinket box
-
21-11-2020 #1
My first attempt at cutting oak. Just a little something for my girlfriend from a few offcuts of oak, I must say it cuts really well. The box was modelled using vcarve and I created a 3d printed jig for holding the heart lid while profiling the top.
Sent from my M2003J15SC using Tapatalk
-
The Following User Says Thank You to CharlieRam For This Useful Post:
-
21-11-2020 #2
Nice work Charlie.
But whatever you don't put a ring in that box and get down on one knee otherwise it will be the last Oak you cut..-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
-
21-11-2020 #3
Cheers Jazz, there's no danger of that happening....I learned the hard way
Sent from my M2003J15SC using Tapatalk
-
25-11-2020 #4
Holy Cow!
That's an amazing piece :0
I love this project showcase section only because of this beautiful and innovative work. Keep going :)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Step clamp design - Hold down thin or irregular shaped objects while milling!
By Lee Roberts in forum Programmers CornerReplies: 5Last Post: 15-04-2012, 12:36 PM
Bookmarks