Threaded View
-
10-03-2021 #9
Just bear in mind that you'll need to grind off any flanges, there's about 36mm of space, I've used 1605 ballscrews and the nut flanges were 40mm across. I ended up grinding 2mm off top/bottom on the Y axis and 4mm off the top on the X axis, centre height on X ended up at 21mm (22.5mm originally).
Also, check the length of your double ballnuts on the y axis: you can probably fit about 23cm of screw in there before it hits the column, so if your nut is 10cm long you'll restrict your travel to 13cm.Last edited by Mat; 10-03-2021 at 01:16 AM.
-
The Following User Says Thank You to Mat For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Warco WM18 or WM16B
By hedeon in forum Milling Machines, Builds & ConversionsReplies: 8Last Post: 25-08-2021, 12:44 PM -
CONVERSION: Warco WM18 Mill Stepper motor advice
By Gotty101 in forum Conversion Build LogsReplies: 7Last Post: 18-08-2018, 05:06 PM -
Siege sx3 or Marco wm18
By terry1956 in forum Machine DiscussionReplies: 3Last Post: 09-02-2017, 12:02 AM -
Super sieg x3 conversions
By dazza in forum Milling Machines, Builds & ConversionsReplies: 2Last Post: 19-02-2014, 10:28 AM -
Wabeco F1410LF vs Warco WM18 vs Sieg X3
By abfa9358 in forum Milling Machines, Builds & ConversionsReplies: 4Last Post: 02-08-2009, 08:23 AM
Bookmarks