Good afternoon,
Has anybody out there got a Pacer router on which they have upgraded the controller and software to modern, supported versions? I have a 25/12HDS with a linear 6 pod tool changer which is stuck in 'demo' mode with a 'safety broken' message and whilst this may be sorted by replacing the dongle code this has proved impossible to source. Basically I have been told that my router is fit only for scrap!!
This, I do not believe, given that the physical parts of the machine are perfectly functional and based around fairly standard, although a bit long in the tooth, motion control systems.
There must be a way to upgrade a machine such as this for significantly less than the cost of a whole new machine, mustn't there?
Any pointers or advice would be much appreciated.
Regards
Darren
www.bagpress.co.uk