Axis not working properly

[JAZZCNC]

Hi George,

Another Ebay machine from the guy in Peter lee I'm guessing.?

I've had a few dealings with his junk machines. You'll have more chance of getting a reply from the Queen than you will him.

The reason you crashed was that the machine doesn't have any HOME (or Limit) switches and because of this SOFT LIMITS cannot be set which would have prevented this from happening.
Aspire as nothing to do with the machine and knows nothing about where you are going to set your ZERO point on the table. Only the machine controller (Mach3) knows this and if it isn't set up correctly or has the needed switches crashes will happen.

All of his machines I've had dealings with have been the same, no homes or limits and poorly set up or not set up at all.

Now without seeing more and a better explanation of exactly what is happening or not happening it's hard to say why it's not working. BUT you mention Resetting the software.! Exactly what did you do.? because if you re-installed Mach3 then it's highly likely you have messed up the settings.

You need to give a better explanation of what you did and what's not working. We/I can help you but you have to help yourself by giving us clear information.