Good advice
However I have a funny feeling I'm not going to far away with him. And plus I get the blame probably for not setting the program right and I crashed to the diode for a second.
I was stand by and soon as the spindle hit the side I was stopped the machine straight away.
Only one thing I changed the mach3 is not letting me reset and keep showing need reset..... So I found one of the forum how I can get that to work.
So that was it but I didn't changed anything .
I think he a few hundreds miles away from me so I can't see he's gonna come and have a look for me.
It's not helping for I'm new for this to but I did managed to get my programs done.
I will try to call him tomorrow and see what happens and what he says.
Unfortunately I need the machine running by now but I can't see that happening any soon.
Just can't get a head around it it was everything was working before now is like half the machine are not responding at all or responding but not going the right direction....
I believe those limit switches can be added to the CNC after?
I mean I do understand what to do next time and probably I misunderstood something but was not very clear.
Now he explained to screw my workpiece down shift the machine to position and set zero,re generate the toolpath and that's it.
But I just did the trial run without tool in and the CNC started the program there were it was sitting.
That is going to be a nightmare but hey ho......my luck.
Thank you for your help and advice.
I will do a update if I spoke with him and see what's happening.
Regards
George