Threaded View
-
16-12-2020 #5
I think it would be simpler and easier for me to stick with micro switches.
So that I am clear on this the connections would be made as follows?
2 micro switches for the X axis into IN2 (already occupied by the emergency stop switch)
2 micro switches for the Y axis into IN3
2 micro switches for the Z axis into IN4
All configured in Mach 3
Sorry if I am confusing the matter it's just electronics are not my strong point here.
Regards
Roy
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Wiring limit switches to latest Banggood 3018 control board
By JBaz in forum Chinese MachinesReplies: 5Last Post: 05-05-2021, 10:44 AM -
New Mach3 settings but limit switches do not work, using a JK02 breakout board help!
By JimK in forum Artsoft Mach (3 & 4)Replies: 1Last Post: 27-09-2019, 11:54 PM -
About homing and switches...
By JW1977 in forum General ElectronicsReplies: 39Last Post: 09-09-2019, 09:16 PM -
Wiring Limit Switches, and can it be done with my control box?
By ravihotwok in forum General DiscussionReplies: 8Last Post: 22-06-2017, 11:23 PM -
EMC2 home/limit switches... only acting as limit?
By vputz in forum LinuxCNC (EMC)Replies: 4Last Post: 15-10-2014, 09:51 AM
Bookmarks