Help with a usb BOB Spindle problems

[Lahdiel]

She's alive once again! Thanks guys i would never have figured out that 10v was an input on my own doh
I still had the isolation board on mine so it only floated about 3v different to earth ground
Thanks again

[Lahdiel]

may have been a bit quick to celebrate then
was working for about an hour until it tripped the RCD and now the spindle tries to spin up and trips the breaker in the back of the cabinet whenever its turned on, the relay that i thought was supposed to control the spindle enable doesn't seem to change much whether its there or not so i was probably wrong about that
this is what i get for working on things when tired i suppose