Just a note on the Wago's - I tried them once (inside my current cabinet, PSU-side) - on 3d-printed retaining clips onto a DIN rail. In a completely static cabinet they're not too bad, but I keep looking longingly at DIN terminals. I wouldn't use them at all for interconnects to motors/sensors etc - they're not designed for an installation intended to be subject to movement. They offer little over DIN terminals other than perhaps cost, and can be fiddly little buggers.

GX25?, they come in 25s? I might need to investigate those!, but for stepper drivers, etc, I've always reverted to the 4-pin XLR connectors. They can still be a bit of a challenge with the limited space in the back-shell, persuading 15mm of stripped cores into the right sequence.

The Amphenols?, beautiful connectors (talking multiway circular connectors... in a nice olive-green) - cut my teeth on those on an early apprenticeship. Definitely the connector of choice if you've bottomless pockets.