Newbie

[Ash88]

I was going to ask the same question as mine didn’t come with any grease.


Could I ask which way you have your switches set?

Does anyone ever have a problem with there vfd just stopping the spindle half way through?
Iv had it twice now, after around 15 mins it just turns the spindle off ( lucky I managed to catch it )
Turned it back on and then stayed on for the next hour and half.

Il check what the wiring over the weekend

Thanks for your help
Ash


Sent from my iPhone using Tapatalk

[JAZZCNC]

I was going to ask the same question as mine didn’t come with any grease.


Could I ask which way you have your switches set?

Does anyone ever have a problem with there vfd just stopping the spindle half way through?
Iv had it twice now, after around 15 mins it just turns the spindle off ( lucky I managed to catch it )
Turned it back on and then stayed on for the next hour and half.

Il check what the wiring over the weekend

Thanks for your help
Ash


Sent from my iPhone using Tapatalk

If the VFD on/off is controlled by the controller then it could be electrical noise on the signal wires. To check this reset the VFD parameter for External control back to the front panel setting and use that to start/stop it. Leave it running and see if happens.

Re grease: Just use any lithium-based grease, DONT use graphite-based grease.