Thread: Triac PC Linuxcnc
Threaded View
-
19-01-2021 #1
Hello, said id throw up my project to document and try get some help.
it was built in 98 and its partially stripped to check the ball screws and condition. My Plan is to use the existing hardware, drivers, spindle controller and run it from a Linuxcnc PC.
This is the Chinese BOB iv ordered. Seems to have a 0-10v output for the spindle.
https://www.aliexpress.com/item/3298...62b94c4dSy2CSf
The circuit diagram below if i understand correctly. The drives output a 12v step and dir. The step and Dir is connected to the collector from the transistor and the emitter to ground. The 5v output from the BOB is connected to a 2k resistor and connected to the Base. When ever the BOB pulses the 5v it pulls 12v from the driver to ground?
[Last edited by JohnT; 19-01-2021 at 08:13 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Mach3/Linuxcnc
By jolyonjenkins in forum Machine Control SoftwareReplies: 3Last Post: 02-08-2020, 11:01 PM -
New to LinuxCNC - Trying to add a PPort card and get LinuxCNC to start
By TnW in forum LinuxCNC (EMC)Replies: 12Last Post: 24-04-2020, 11:01 AM -
What do I need to run LinuxCNC???
By gatesy in forum LinuxCNC (EMC)Replies: 22Last Post: 02-12-2015, 07:42 PM -
Mach3 vs LinuxCNC/EMC What do you use and why?
By Lee Roberts in forum Machine Control SoftwareReplies: 46Last Post: 26-11-2013, 01:02 AM -
How many LinuxCNC/EMC users do we have?
By birchy in forum LinuxCNC (EMC)Replies: 16Last Post: 30-12-2012, 08:08 PM
Bookmarks