. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 25-06-2022 #14
    JohnT's Avatar
    Lives in Cork, Ireland.
    JohnT
    Last Activity: 03-02-2025 Has been a member for 4-5 years. Has a total post count of 22.
    Waiting on some parts to come to tackle the homing sensors.
    I need a bit of help with the Spindle. I have the spindle working by grounding the SGR relay and hooking up a 9v battery (it's at about 4v) and it's spinning fine. My issue the spindle control board is not isolated.

    I have the BOB feed with the machine cabinets 24v power. On the Bob it has a 0-10v opto isolated output for spindles. I'm afraid to connect this incase I blow something. Would changing the power feed to the Bob from separate transformer power supply isolate it ? The BOB I have is the same as below.

    MACH3V2.1
    https://a.aliexpress.com/_uzGXvi
    Last edited by JohnT; 25-06-2022 at 05:15 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Mach3/Linuxcnc
    By jolyonjenkins in forum Machine Control Software
    Replies: 3
    Last Post: 02-08-2020, 11:01 PM
  2. New to LinuxCNC - Trying to add a PPort card and get LinuxCNC to start
    By TnW in forum LinuxCNC (EMC)
    Replies: 12
    Last Post: 24-04-2020, 11:01 AM
  3. What do I need to run LinuxCNC???
    By gatesy in forum LinuxCNC (EMC)
    Replies: 22
    Last Post: 02-12-2015, 07:42 PM
  4. Mach3 vs LinuxCNC/EMC What do you use and why?
    By Lee Roberts in forum Machine Control Software
    Replies: 46
    Last Post: 26-11-2013, 01:02 AM
  5. How many LinuxCNC/EMC users do we have?
    By birchy in forum LinuxCNC (EMC)
    Replies: 16
    Last Post: 30-12-2012, 08:08 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules