. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 19-01-2021 #1
    Doddy's Avatar
    Lives in Preston, United Kingdom.
    Doddy
    Last Activity: 08-02-2024 Has been a member for 9-10 years. Has a total post count of 1,364. Received thanks 188 times, giving thanks to others 66 times. Referred 1 members to the community.
    Quote Originally Posted by JohnT View Post
    The circuit diagram below if i understand correctly. The drives output a 12v step and dir. The step and Dir is connected to the collector from the transistor and the emitter to ground. The 5v output from the BOB is connected to a 2k resistor and connected to the Base. When ever the BOB pulses the 5v it pulls 12v from the driver to ground?
    That circuit - if the BoB is outputting 5V, it will let the input to the stepper driver float to 12V as reported. If the BoB output is 0V then the input to the stepper driver will be dragged to 0V.

    You draw the BoB with an output transistor - as shown this inverts the 'step' signal from the BoB - is this your intent?
    Last edited by Doddy; 19-01-2021 at 06:35 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Mach3/Linuxcnc
    By jolyonjenkins in forum Machine Control Software
    Replies: 3
    Last Post: 02-08-2020, 11:01 PM
  2. New to LinuxCNC - Trying to add a PPort card and get LinuxCNC to start
    By TnW in forum LinuxCNC (EMC)
    Replies: 12
    Last Post: 24-04-2020, 11:01 AM
  3. What do I need to run LinuxCNC???
    By gatesy in forum LinuxCNC (EMC)
    Replies: 22
    Last Post: 02-12-2015, 07:42 PM
  4. Mach3 vs LinuxCNC/EMC What do you use and why?
    By Lee Roberts in forum Machine Control Software
    Replies: 46
    Last Post: 26-11-2013, 01:02 AM
  5. How many LinuxCNC/EMC users do we have?
    By birchy in forum LinuxCNC (EMC)
    Replies: 16
    Last Post: 30-12-2012, 08:08 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules