Triac PC Linuxcnc

[JohnT]

I'll order one and give it a try. I'll hook up 24v from the machine cabinets PSU. And the 0-10v from the Bob to input 1.(LV side). For the HV side, it looks like the terminal for 0-10v connects to the output 1. The power and ground come from another isolated power source?

[Doddy]

I'll order one and give it a try. I'll hook up 24v from the machine cabinets PSU. And the 0-10v from the Bob to input 1.(LV side). For the HV side, it looks like the terminal for 0-10v connects to the output 1. The power and ground come from another isolated power source?

If you was to write a pot on the spindle controller, you should have 3 pins on the spindle controller to attach to, what are those? Likely a good candidate for the HV supply side (and the pot input)

Sorry, reading on phone during demo at work, can’t review the full thread here. What is the spindle controller model?