Triac PC Linuxcnc

[JohnT]

Got the board in the mail today. Wired it up works away fine :) I'm getting 8.5v max with 10v imputed. I'll play away with it a bit more and see can I get it closer to 10v on the output. Waiting on more bits from China to tackle those homing sensors. Thanks again Doody.

https://youtube.com/shorts/gTI93IFkSJ4?feature=share

[dazp1976]

Got the board in the mail today. Wired it up works away fine :) I'm getting 8.5v max with 10v imputed. I'll play away with it a bit more and see can I get it closer to 10v on the output. Waiting on more bits from China to tackle those homing sensors. Thanks again Doody.

https://youtube.com/shorts/gTI93IFkSJ4?feature=share

You won't get 10v out if you only put 10v in. You get voltage drop through the circuits. Needs at least 12v inputing.

[JohnT]

No it's 10v inputted by the BOB's 0-10v . It's supplied with 12v from the Bob and 24v on the other side
If the opto chips had an ID I could find out what pins has the 0-10v signal. My guess the 12v power from the Bob isn't enough