Thread: Triac PC Linuxcnc
Threaded View
-
08-07-2022 #27
Last Activity: 03-02-2025
Yes iv ordered a slightly different board. It has two input/outputs instead of one. Behind the two terminals they are
L7818cv GKDEG V6 CHN 941
8pin surface mount chips are unmarked aswell. Typical China lol
The two 8pin chips in the middle are blank, no ID.(I have the dual model)
Iv mistakinly ordered the 5v5v version instead of the 12v12v version. But there are two pots on the board to alter output. It's maxed out at 8.5v. it states on the page you need 24-32v if you are using 0-10v. I have it hooked up 12v from the Bob (may need higher V)and a separate 24v PSU to the isolator board. Iv checked the sprint board and it has two pots for min and max speed.Last edited by JohnT; 08-07-2022 at 12:33 PM.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Mach3/Linuxcnc
By jolyonjenkins in forum Machine Control SoftwareReplies: 3Last Post: 02-08-2020, 11:01 PM -
New to LinuxCNC - Trying to add a PPort card and get LinuxCNC to start
By TnW in forum LinuxCNC (EMC)Replies: 12Last Post: 24-04-2020, 11:01 AM -
What do I need to run LinuxCNC???
By gatesy in forum LinuxCNC (EMC)Replies: 22Last Post: 02-12-2015, 07:42 PM -
Mach3 vs LinuxCNC/EMC What do you use and why?
By Lee Roberts in forum Machine Control SoftwareReplies: 46Last Post: 26-11-2013, 01:02 AM -
How many LinuxCNC/EMC users do we have?
By birchy in forum LinuxCNC (EMC)Replies: 16Last Post: 30-12-2012, 08:08 PM
Bookmarks