-
03-02-2021 #11
Hi routercnc and JAZZCNC,
Thank you for the comprehensive replies!
I have been watching and reading my way through build logs and guides and hadn't come across a discussion concerning the usage of the Z-axis in the way you've laid out above. I guess at that point it's presumed that the thread starter knows their use parameters and is only after mechanical analysis.
Thanks again for the replies everyone. That's cleared up a lot for me!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
BUILD LOG: Router Build number 2
By charlieuk in forum DIY Router Build LogsReplies: 91Last Post: 03-07-2018, 10:21 PM -
Physics, Metallurgy and Common Sense? No!
By magicniner in forum General DiscussionReplies: 10Last Post: 09-06-2018, 08:30 PM -
Beginner in CNC trying to decide on number of axes
By doc7 in forum General DiscussionReplies: 13Last Post: 18-05-2017, 03:24 PM -
WANTED: part number
By tinshak in forum Items WantedReplies: 4Last Post: 10-02-2015, 10:10 PM -
Make your own Super- PID ... not that hard to make ! .... says electronics genius!
By Buba b in forum General ElectronicsReplies: 4Last Post: 26-04-2013, 08:37 AM
Bookmarks