Problem with Boxford TCL lenze controller

[John11668]

well, actually mines for the spindle of a 190vmc not a lathe, i'm using a dc powered pwm controller

Where did you source yours Lahdiel

[John11668]

Was looking at this
https://inverterdrive.com/group/DC-T...n-Isolated-1Q/

Guys at inverterdrive reckon it should handle the motor which I believe is 490 w , so will report back .

[Lahdiel]

i built my own but you can find similar to what i'm using looking up 60v pwm controller, not sure what voltage yours will be but i've seen over 100 intended for those spindles on routers