. .
Page 3 of 3 FirstFirst 123
  1. #21
    I've been using them on both my lathes and they have been fine. There's no real option to tune the drives themselves but you can tune the higher level system. I have closed loop position control on one of them (the Bantam, using Linuxcnc and glass scales) and the response is pretty impressive. Main thing is to make sure the torque and power are adequate for your machine. Best to err on the safe size, not least as they are fairly low cost. The other thing I did was change the fans, which sounded like a nest of angry wasps.


  2. The Following User Says Thank You to Muzzer For This Useful Post:


Page 3 of 3 FirstFirst 123

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to setup Chinese AASD Servo electronic gearing
    By JAZZCNC in forum Machine Discussion
    Replies: 12
    Last Post: 02-07-2022, 03:11 PM
  2. Servo Manuals - Chinese Sellers
    By Chaz in forum General Electronics
    Replies: 1
    Last Post: 30-04-2019, 12:12 PM
  3. Tuning software
    By D-man in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 12-02-2017, 11:59 AM
  4. Servo Tuning - any experts here ?
    By Davek0974 in forum Machine Discussion
    Replies: 3
    Last Post: 08-09-2016, 08:10 PM
  5. eBay: SEM SERVO MOTOR SEM MT30 U4-48, LAMBDA psu,s, 160v servo drive
    By dazza in forum Items On eBay UK
    Replies: 0
    Last Post: 29-01-2015, 08:55 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •