TT wall art

**pippin88** · 01-03-2021

Did you leave it sitting flat overnight?

Better to position for even airflow (upright with both faces exposed)

**CharlieRam** · 01-03-2021

Originally Posted by pippin88

Did you leave it sitting flat overnight?

Better to position for even airflow (upright with both faces exposed)

It was left clamped for a few days but there was plenty of airflow below the workpiece....I'm not sure if you could tell from the image but I had it screwed through the back supported on the top and bottom edge only, I removed 9mm leaving 10mm panel thickness at the deepest points. It bowed by approximately 0.5mm on each end, probably just the wood relaxing so now I'm aware I will change methods slightly. My workmate is happy enough though :)