Threaded View
-
11-03-2021 #2
You're probably looking at a bit less than a Cyclone.
3 phase will put off quite a few people.
Easiturn's aren't as production friendly as Cyclones (non-slant bed, and not fully enclosed), but tailstock can add to desirability, so limited market for anybody looking for a compact production machine.
I think the demand for older controls is diminishing, so I'm not even sure it would be desirable for somebody just wanting it for the controller.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
MCB Sizes for Denford Easiturn 3
By Colin Barron in forum Electronic Project BuildingReplies: 0Last Post: 22-01-2021, 05:10 PM -
Denford Easiturn 3 spindle alignment
By Nemo1966 in forum Denford LathesReplies: 3Last Post: 13-05-2020, 10:28 AM -
denford easiturn
By scotty in forum General ElectronicsReplies: 8Last Post: 27-06-2016, 09:24 PM -
Denford Easiturn pnc2c
By Colin Barron in forum Lathes, Lathe Rebuilding & ConversionsReplies: 0Last Post: 28-02-2016, 05:49 PM -
Eazicnc on denford easiturn
By pistolknight in forum Denford LathesReplies: 2Last Post: 24-11-2011, 07:55 PM
Bookmarks