-
28-03-2021 #21
Good news and Bad news............
Good, I have the mill under control from mach3 via the UC400ETH
I had to fiddle around a bit, the CNCDrive manual didn't work perfectly for me.
Bad, I've discovered I hadn't kept a backup of my mach3 machine profile somewhere other than on the computer that I used to control it (and which died a sudden death)
So I am plodding through ALL the settings, including faffing with the acceleration etc.
I'm sure everyone else is much more organised than me, but if you haven't got your profile saved somewhere else, I really recommend you do it asap!
-
25-04-2021 #22
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Looking for parallel port cable
By eurikain in forum Computer HardwareReplies: 3Last Post: 20-02-2016, 01:51 AM -
Grounding help, UCCNC, UC300 and connection loss
By gabi68 in forum CNCdrive (UC100, UC300ETH)Replies: 6Last Post: 14-10-2015, 07:42 PM -
parallel port address
By Dan Brown in forum Artsoft Mach (3 & 4)Replies: 6Last Post: 07-01-2010, 12:04 PM -
Laptop, ie no parallel port?
By tompsky in forum Laptops & TabletsReplies: 3Last Post: 11-11-2008, 07:12 PM
Bookmarks