Thread: Strange problem
-
21-03-2021 #11
I may have nailed the problem down?
Because I was getting the repeated bad results from the hardware I was using, I decided to change all the electronics again.
I used a new Arduino UNO, programmed it with the original GRBL 1.1h and then I tried again using the same CNC shield.
Same problem. So next I also changed the CNC shield for a new one, checked all my wiring very carefully and tried again.
Same problem.
I was starting to think maybe the is something wrong in the software, so I opened up Universal G-code Sender and tried that.
Straight away everything worked, I could home and travel in all directions without any problems.
So next I closed UGS and opened up LaserGRBL again, and tried again. Back to the same problem, so to me it is something that LaserGRBL is doing.
-
22-03-2021 #12
Problem confirmed. I loaded an old version of LaserGRBL and it works perfectly, so the new version has a jogging problem.
-
22-03-2021 #13
I bet you swore at that point :)
-
22-03-2021 #14
Still swearing, still not fixed as it is a software problem!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Spoilboard surfacing - strange problem/result
By Nealieboyee in forum Gantry/Router Machines & BuildingReplies: 10Last Post: 30-04-2019, 09:11 PM -
strange goings on
By Kev2960 in forum Chinese MachinesReplies: 2Last Post: 19-05-2017, 09:37 AM -
Strange problem, possibly missing steps?
By Philly in forum Chinese MachinesReplies: 5Last Post: 26-10-2012, 06:36 PM -
Z acting Strange
By m.marino in forum Machine DiscussionReplies: 2Last Post: 06-03-2012, 09:30 PM -
a strange question
By Dan Brown in forum Programmers CornerReplies: 15Last Post: 21-12-2009, 01:00 PM
Bookmarks