Quote Originally Posted by Tick View Post
Good to know that I am not too far off with the electronics.

I really appreciate the help, building from scratch is a pretty daunting process but I do enjoy a challenge!
Ah, I didn't look at the electronics but you didn't really give much info other than motor size which doesn't really help as there are other factors that are important, like inductance and psu voltage, etc.Then you have the drives to consider which you don't mention.

Also, I don't know anything about the Oznest control, but if it's one of those Gbrl things which runs on arduino then I wouldn't bother, spend a little more and put a decent ethernet motion controller which runs on good software.

But your long way from needing any of that stuff and my advice would be don't buy any of the electronics until it's needed or close to being needed. Do the research and you'll see why Gbrl and all those tinpot control systems are a bad idea.

The building is easy enough provided you break it down into bite-size chunks, treat it like eating an elephant, one small bite at a time.