-
10-04-2021 #11
Nut would appear to be similar apart from the radiused sides, is there room for this . What is the damage to the screw, can't see any in the pics
NO switches are not fail safe, I never use them as limits or in ES positions
-
10-04-2021 #12
Yes there is room for the radiused sides, and the damage was to the plastic part holing the bearings in place. I have tried without success to repack the bearings but even with carefull assembly its got very tight spots.. and the plastic sleeves on the lower part are damaged..
Yes I understand my switches wer'nt fail safe and seems my soft limits didnt help.. As far as Im aware I think one of my sons had been using the machine or maybe from a broken wire on the switch ( not set up diffrently) ? An in my error I didnt check things before I used it (rush job) :(
-
10-04-2021 #13
OK will try to get it machined this weekend
-
10-04-2021 #14
How much ? ect and thanks
-
10-04-2021 #15
Have sent PM
-
The Following User Says Thank You to johnsattuk For This Useful Post:
-
10-04-2021 #16
pm sent
-
16-04-2021 #17
Many thanks for the help from johnsattuk saved the day... I am now up and running
amazing help when needed most :)
-
19-04-2021 #18
-
19-04-2021 #19
Already done that now thanks .... all NC
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Hello everyone, bespoke spectacle maker in London pulling my hair out.
By Worshipfulspectacles in forum New Member IntroductionsReplies: 13Last Post: 23-11-2019, 02:33 AM -
pulling my hair out with cam
By universally in forum CAD & CAM SoftwareReplies: 6Last Post: 09-04-2015, 01:41 PM -
Hair growth device. DIY version
By gavztheouch in forum Electronic Project BuildingReplies: 16Last Post: 30-03-2014, 08:55 PM -
AM882,s and Mach3 ......plus hair removal !!!
By Buba b in forum Motor Drivers & ControllersReplies: 3Last Post: 26-10-2012, 05:11 PM -
Heelp! Dual axis steppers.. Losing steps.. Pulling hair out..!
By fasteddy in forum Motor Drivers & ControllersReplies: 9Last Post: 14-05-2010, 02:32 PM
Bookmarks