Thread: USB - Ethernet adapter for UCCNC
Threaded View
-
09-04-2021 #1
I'm about to embark on the exciting task of changing my router controller from LinuxCNC driving a cheapo parallel interface to UCCNC and an AXBB-E. Currently I have a laptop with an Ethernet port but it's a bit long in the tooth and I'm looking at replacing it. Most laptops these days come without Ethernet, relying on wireless connection into networks instead. Does anyone have experience of using a USB - Ethernet asdapter like the one linked below? If so are there any problems?
Does anyone use wireless to link UCCNC on a laptop into their home network and then an Ethernet port into an AXBB-E? Sounds dodgy but I'd be interested to know if it works reliably.
Kit
https://www.pccasegear.com/products/...etwork-adapterAn optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
USB to Ethernet
By iforeman in forum CNCdrive (UCCNC)Replies: 8Last Post: 23-06-2020, 05:13 PM -
running mach 3 with a usb to parallel adapter
By Kendrick57 in forum Artsoft Mach (3 & 4)Replies: 40Last Post: 06-01-2020, 04:49 PM -
Mach 3 - Paralell port to ethernet adapter Windows 10 64Bit
By myles.merry in forum Artsoft Mach (3 & 4)Replies: 4Last Post: 27-05-2019, 11:35 PM -
Why Ethernet instead of USB?
By jtar40 in forum Motor Drivers & ControllersReplies: 15Last Post: 05-04-2018, 10:08 PM -
Where to buy that adapter female 16x1.5mm / male 1/2 NPT
By Boyan Silyavski in forum Marketplace DiscussionReplies: 8Last Post: 25-06-2015, 08:43 AM
Bookmarks