Thread: USB - Ethernet adapter for UCCNC
Threaded View
-
09-04-2021 #5
Doddy, Neale,
Thanks to both for the advice. There's nothing on the CNCDRIVE website about this and I was concerned about problems with the software finding the ethernet port. I suppose with the USB adapters being so cheap I could buy one and test it on the existing laptop before comitting to a new machine without a real ethernet card inside. Laptops with network ports are still available if it does prove to be a problem.
KitAn optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
USB to Ethernet
By iforeman in forum CNCdrive (UCCNC)Replies: 8Last Post: 23-06-2020, 05:13 PM -
running mach 3 with a usb to parallel adapter
By Kendrick57 in forum Artsoft Mach (3 & 4)Replies: 40Last Post: 06-01-2020, 04:49 PM -
Mach 3 - Paralell port to ethernet adapter Windows 10 64Bit
By myles.merry in forum Artsoft Mach (3 & 4)Replies: 4Last Post: 27-05-2019, 11:35 PM -
Why Ethernet instead of USB?
By jtar40 in forum Motor Drivers & ControllersReplies: 15Last Post: 05-04-2018, 10:08 PM -
Where to buy that adapter female 16x1.5mm / male 1/2 NPT
By Boyan Silyavski in forum Marketplace DiscussionReplies: 8Last Post: 25-06-2015, 08:43 AM
Bookmarks