Will be assembling my x carve soon... Once I have

[MikeS]

.... constructed a work table for it to go on.
I've started cutting up the sheet material using my Track Saw. ... I hope the jpeg of the plans I have drawn loads up.

The design is a folding table as my workspace is multi purpose. Once folded down the whole unit will only be 600mm wide... Though quite long (1.6m approx) as I have included a cupboard with four plastic trays and a pull out surface for the control unit and also a laptop.

The design is based upon one I saw on you tube which seemed quite innovative... The only additional adaptation I might make is the possible fitting of a couple of gas struts as used in hatchback cars to make lifting easier....