The axes X Y are perpendicular.
Baklash is not larger than 0.05 mm
I use Hybrid Servo Drive HBS86H for drive.
I use POKEYS 57E for control.
I also added control from the LPT port, but the error did not decrease
(Toolpaths used in this file:)
(Profile 1)
(Tools used in this file: )
(1 = End Mill {12 mm}kokam)
N100G00G21G17G90G40G49G80
N110G71G91.1
N120T1M06
N130 (End Mill {12 mm}kokam)
N140G00G43Z20.010H1
N150S16000M03
N160(Toolpath:- Profile 1)
N170()
N180G94
N190X0.000Y0.000F2000.0
N200G00X-39.000Y-37.000Z20.000
N210G00Z2.000
N220G1Z0.000F2000.0
N230G1Y-7.000Z-5.000
N240G1Y37.000
N250G2X-37.000Y39.000I2.000J0.000
N260G1X37.000
N270G2X39.000Y37.000I0.000J-2.000
N280G1Y-37.000
N290G2X37.000Y-39.000I-2.000J0.000
N300G1X-37.000
N310G2X-39.000Y-37.000I0.000J2.000
N320G1Y-7.000
N330G00Z20.000
N340G00Z20.010
N350G00X0.000Y0.000
N360M09
N370M30
%