Denford stepper motor

[Edendale]

Yes oiled well and slides freely, I disconnected the stepper motor and ran a program and it still does it so looks like the motor or wiring may be the problem, do denford still carry spares for old machines ! Regards Mike

[Clive S]

Yes oiled well and slides freely, I disconnected the stepper motor and ran a program and it still does it so looks like the motor or wiring may be the problem, do denford still carry spares for old machines ! Regards Mike

It could be the drive or cabling First is to check with a meter both phases of the stepper post a picture of the drive and connections to the stepper there will be 4 wires to the stepper ie 1 pair for each coil.

It is unusually for a stepper to fail.

Don't unplug the stepper with the drive powered

[Edendale]

Thanks Clive, it would appear that it is the cable going into the motor, as it moves there must be a break in the wire, it looks like the wiring is connected directly to the windings so not sure if it’s the cable or the thin copper wire on the winding that’s the problem, I’ll have a look tomorrow, ��

[andy_con]

Thanks Clive, it would appear that it is the cable going into the motor, as it moves there must be a break in the wire, it looks like the wiring is connected directly to the windings so not sure if it’s the cable or the thin copper wire on the winding that’s the problem, I’ll have a look tomorrow, ��

I had a cable break on my Denford triac, so it does happen.

It was the cable going into the stepper, not the stepper wiring

[Clive S]

Thanks Clive, it would appear that it is the cable going into the motor, as it moves there must be a break in the wire, it looks like the wiring is connected directly to the windings so not sure if it’s the cable or the thin copper wire on the winding that’s the problem, I’ll have a look tomorrow, ��

Don't open the motor up. Did you check the ohms between each phase they should be around 1-2 ohms across each coil.

You are not giving any info back so it is hard to guess.

[Edendale]

Hi Clive, your advice to not open the stepper motor came to late I’m afraid, but I have checked all wires, and I think the break is in the chain, looks like I’m going to have to replace all the wiring,

[JAZZCNC]

Hi Clive, your advice to not open the stepper motor came to late I’m afraid, but I have checked all wires, and I think the break is in the chain, looks like I’m going to have to replace all the wiring,

Well, don't be surprised if it doesn't work properly when you do find the cause because they rarely work the same after being taken apart.

[Edendale]

O dear, any idea where I buy a replacement from