Machine control software

[A_Camera]

Ah yes.
However. Their controllers run Mach too so you just switch back to it as and when needed. Simple.

By the way.
UCCNC TURN forum:
https://www.forum.cncdrive.com/viewforum.php?f=20

Yes, but personally I have not used Mach3 ever since I switched to UCCNC.

[dazp1976]

Yes, but personally I have not used Mach3 ever since I switched to UCCNC.

Well. I hope UCCNC is as good as it sounds...
I've just bought...
A UC300ETH, 2* UCBB boards, extra cables, and a license.
IDC26 and IDC16 screw terminal boards.
Some 8 channel relay modules.
Some multi channel optocoulper modules.
And various other bits and bobs.

That'll keep me busy for a little while sorting all that lot out
Have loads of boxes stacked on the sofa, mrs keeps looking at them with a bit of a frown