Thread: Newbie PSU calculations
Hybrid View
-
22-05-2021 #1
Cheers for that. The fan in the servo drive is pretty damn loud.
I was originally just going to mount it open on the wall next to the machine until I heard the noise.
I've bought a bigger control box so I can get everything else + the servo drive inside it together and see if that helps.
If it still bugs me, then I'll give the fan swap a go
I'm still early days bench testing atm with my old parallel bob & Mach3 to get a feel for it (and confidence with servo's).
I'm playing will all setups, PWM, step/dir, axis, relay & opto modules etc.
I have loads of time on my hands to fiddle, and learning a fair bit :)
I'll start on benching the UC300eth next week with Mach and UCCNC.
I want to get a good feel for UC and get the controller working perfectly with both softwares first.
Then I'll fit up the new box and put them to machine.
Got myself a stepperonline driver for my Z last week too. DM860T (takes up to 80Vac or 110Vdc).
Putting 80Vdc to it which should give my Z (nema34 1080oz) a kick up the a**e
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Ballscrew design and 12vdc rpm and torque calculations help required
By rjsutton in forum Machine DiscussionReplies: 6Last Post: 13-09-2019, 04:03 AM -
Check my power supply calculations?
By Nealieboyee in forum Machine DiscussionReplies: 9Last Post: 04-12-2018, 08:27 PM -
Lathe spindle dividing - resolution calculations and help!
By craynerd in forum General DiscussionReplies: 3Last Post: 18-06-2018, 01:23 AM -
Y and Z axis set up.....calculations
By dudz in forum Gantry/Router Machines & BuildingReplies: 7Last Post: 31-01-2014, 01:54 PM
Bookmarks