CNC Machine Support Table

[WoodKnot]

Good morning -

I decided that i really needed to lay out the top for the table and see how much room it really will take up.



So a half sheet of 22mm MR MDF on a mock up frame to get the feel for it.



It does cause me some issues and will have to move some stuff around yet again!!

The top square sheet is a 1000mmx1000mm board that i was going to use for my spoiler board.

I was thinking of making this up like my microjig system, a pattern of dove tailed rebates to create a flexible hold down grid.

I appreciate i can't use the clamps as per the image



So, its a tight fit, but i can squeeze it in -

Time to go and purchase some 4x2 framing timber to make a good solid sturdy frame with plenty of braces.

It will also make me a large lower storage area. I was also thinking of having a large pull out drawer underneath for the electronics and laptop.

Another image of my workshop, Where i eat sawdust Doddy!!



WoodKnot