. .
Page 4 of 4 FirstFirst ... 234
  1. #31
    Update on the resonance issues. David sent me replacement driver modules which I was initially very skeptical about however they have totally eliminated the problem. Ive run a profile which, prior to the change, was causing terrible vibration and noise but now runs totally smoothly. I can barely even hear the motors now.

    I must say a huge thanks to Dean who was very supportive. He chatted with me over the phone and gave some excellent advice. I think Deans machines look of a very high spec and he obviously knows what he's talking about and as much as I would love to own one of his builds they are unfortunately a little beyond my budget at the moment.

    A few have told me to send this cnc back but so far David has been very supportive and since my original complaint has been suitably resolved I don't have a valid reason to return it - nor would I want to. He has done an honest days job and I have what I paid for.

  2. #32
    Pleased you are a little further forward and hope it goes well for you.
    -use common sense, if you lack it, there is no software to help that.

    Email: [email protected]

    Web site: www.jazzcnc.co.uk

  3. The Following User Says Thank You to JAZZCNC For This Useful Post:

Page 4 of 4 FirstFirst ... 234

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Is this normal?
    By Pete147 in forum Control Hardware & Systems
    Replies: 5
    Last Post: 03-06-2021, 10:24 PM
  2. Is this normal?
    By A_Camera in forum Belt Drive, Pulleys & Timing
    Replies: 19
    Last Post: 28-04-2021, 08:12 PM
  3. Replies: 27
    Last Post: 23-12-2020, 09:49 PM
  4. 1st time setting up.. whats normal..
    By Marlin in forum Motor Drivers & Controllers
    Replies: 26
    Last Post: 01-09-2014, 04:53 PM
  5. Looks like the normal first page has gone awry.... or is it my PC?
    By WandrinAndy in forum General Discussion
    Replies: 22
    Last Post: 03-10-2012, 08:05 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts