Thread: Does this sound normal?
Hybrid View
-
20-06-2021 #1
No, it does not sound right. I'm leaning towards electrical problem rather than mechanical, especially running at a higher feed rate removes it. Check all the electrical connections are tight.
Interesting that jogging is OK but running code is not. Are these both at the same feed rate? If you use feed rate override then jog the machine slower manually is it still OK?
Which software generated the g-code? Maybe paste it here in case there is something odd there.
-
The Following User Says Thank You to routercnc For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Is this normal?
By Pete147 in forum Control Hardware & SystemsReplies: 5Last Post: 03-06-2021, 10:24 PM -
Is this normal?
By A_Camera in forum Belt Drive, Pulleys & TimingReplies: 19Last Post: 28-04-2021, 08:12 PM -
Looking for an economical XY (well and Z) solution that is not for the normal use
By SparkyLabs in forum Linear & Rotary MotionReplies: 27Last Post: 23-12-2020, 09:49 PM -
1st time setting up.. whats normal..
By Marlin in forum Motor Drivers & ControllersReplies: 26Last Post: 01-09-2014, 04:53 PM -
Looks like the normal first page has gone awry.... or is it my PC?
By WandrinAndy in forum General DiscussionReplies: 22Last Post: 03-10-2012, 08:05 PM
Bookmarks