. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 21-06-2021 #17
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Quote Originally Posted by grantx View Post
    Well, that is a very discouraging read.

    Yes, I bought it new from David Ward in Peterlee. It is less than 2 weeks old and he's not returning my calls anymore (he probably found this thread).
    Like I said I'm very sorry to have to say it and it's wrong that should need to. Also, I don't think he's not answering because of reading this thread, I've had others contact me privately and he doesn't answer their calls either.!

    Quote Originally Posted by grantx View Post
    His advert on Ebay says I can return within 2 weeks but the problem is that I didn't pay him through ebay - it was done privately.
    If you got a receipt then shouldn't matter how you paid him. I also believe you have 30days under your statutory rights to return the machine, but I'm no expert so check it out.


    Quote Originally Posted by grantx View Post
    What do you think is the best way forward from here?
    If it was me then I'd be returning it without a doubt but only you can make that decision.
    -use common sense, if you lack it, there is no software to help that.

    Email: [email protected]

    Web site: www.jazzcnc.co.uk
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to JAZZCNC For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 6 users browsing this thread. (0 members and 6 guests)

Similar Threads

  1. Is this normal?
    By Pete147 in forum Control Hardware & Systems
    Replies: 5
    Last Post: 03-06-2021, 10:24 PM
  2. Is this normal?
    By A_Camera in forum Belt Drive, Pulleys & Timing
    Replies: 19
    Last Post: 28-04-2021, 08:12 PM
  3. Looking for an economical XY (well and Z) solution that is not for the normal use
    By SparkyLabs in forum Linear & Rotary Motion
    Replies: 27
    Last Post: 23-12-2020, 09:49 PM
  4. 1st time setting up.. whats normal..
    By Marlin in forum Motor Drivers & Controllers
    Replies: 26
    Last Post: 01-09-2014, 04:53 PM
  5. Looks like the normal first page has gone awry.... or is it my PC?
    By WandrinAndy in forum General Discussion
    Replies: 22
    Last Post: 03-10-2012, 08:05 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules