Thread: Does this sound normal?
Hybrid View
-
20-06-2021 #1
Even 60Vdc isn't enough to reliably run 34's in my view.
I know I'm talking of a mill with gibs here and routers are looser running, but still., I could not get my 1080oz reliably above 450rpm (2250mm/min).
I've bought a new driver for that particular motor (110vdc/80Vac) and upping to 80Vdc as a tester to see if there's any increase in performance. (Will be a while yet, still building new control box).
Will eventually go all AC.
With the X & Y I swapped motors to 566oz nema 24's keeping voltage 60vdc and 860 drivers the same.
It's twice as fast with those 2 on there.
It's shocking how many people get screwed over these days with misleading specs and advertising.
At least if you D.I.Y. it you can over engineer the damn things!. (you can also go too far there though).
-
The Following User Says Thank You to dazp1976 For This Useful Post:
-
20-06-2021 #2
Yes, I agree but in this case, with small Nm NEMA 34's like fitted on this machine then 60Vdc or more should get them to close 1000rpm. It's a combo of 5mm and low rpm which cripples the speed.
Don't get hung up on AC, the only advantage is you don't have to mess around building DC PSU's. Even with AC power the drives convert this to DC for the motors.-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
Thread Information
Users Browsing this Thread
There are currently 10 users browsing this thread. (0 members and 10 guests)
Similar Threads
-
Is this normal?
By Pete147 in forum Control Hardware & SystemsReplies: 5Last Post: 03-06-2021, 10:24 PM -
Is this normal?
By A_Camera in forum Belt Drive, Pulleys & TimingReplies: 19Last Post: 28-04-2021, 08:12 PM -
Looking for an economical XY (well and Z) solution that is not for the normal use
By SparkyLabs in forum Linear & Rotary MotionReplies: 27Last Post: 23-12-2020, 09:49 PM -
1st time setting up.. whats normal..
By Marlin in forum Motor Drivers & ControllersReplies: 26Last Post: 01-09-2014, 04:53 PM -
Looks like the normal first page has gone awry.... or is it my PC?
By WandrinAndy in forum General DiscussionReplies: 22Last Post: 03-10-2012, 08:05 PM
Bookmarks