Quote Originally Posted by mekanik View Post
Main reason for using water cooled Spindle is the noise or lack thereof, you need an inverter as they they are three phase, you need to provide a small tank and a pump. you will be fine with an ordinary router but again it's the noise, this would get very old if you are doing a long run on the machine, you need also to be looking at a dust shoe to fit whatever device you wish to use.
Good luck
Regards
Mike
The motors then are quite large? Even compared to a good half inch router then?

Can you recommend a pump and tank Mike - it sounds like an aquarium!

Just trying to figure out what I will need -

WoodKnot