Hello,

So good news, bad news. I loaded the probing screen and macros to 1.2111 The install went fine but the odd behaviour is the same as 1.2113. It looks like my issue is not UCCNC Version related.
Settings used in the following video.
PT 0
PD 2
PS 10
FC 8
XY R 20
FP 100
FnP 20
PDp - 3

Units mm

The probe is on Pin 2 Port 2 Active high
Diag Page shows
I2 on. Led off in i/o function monitor
Trigger probe and
I2 off Led on in i/o function monitor
Nothing shown in Status monitor

The video shows 3 probe routines one after the other. Z height, X plus, and X Center.

https://youtube.com/shorts/qKcTbbINDEE?feature=share

I suppose I should start to break the issue down, check the UCCNC set up, probe settings, then try some simple probe moves!

Can anyone suggest a check for the probe wiring and UCCNC Settings?

Simon

Sent from my COL-L29 using Tapatalk