I have measured the force on my probe and the normally closed circuit opens at 25 grams.
I was going to do a few G31 commands in MDI to see what happened but decided to check out the UCCNC probing page just as a check of my set up. I am not a huge fan of it because I find it too easy to probe the wrong axis. Anyway the video belows shows its single axis probing cycle acts as expected.

https://youtube.com/shorts/JtA8sqNOW3o?feature=share

It would have been nice to use your, far less confusing screen but for some reasons the stars are not lining up for me. Thanks for your help and patience.

Sent from my COL-L29 using Tapatalk